Filter
Top Products
1 – Introduction—What is finalizing?
7
ENGLISH
What is finalizing?
Even after audio data is recorded on a CD-R or CD-
RW disc, it cannot be played back on a conventional
CD player until the final TOC
(*)
data has been
recorded on the disc. The process of recording this
TOC data is called “finalizing”.
No further recording can be performed on a finalized
disc. However in the case of a CD-RW, the disc can be
“un-finalized” to allow additional recording (
→
p.31).
* TOC: Table of Contents = information about the
recorded data, such as the number and playing
times of the songs
Using the remote control unit
Cautions for use
• Remote control operations may not be possible if
the remote control receiver is in direct sunlight or
under intense illumination.
• Please be aware that operating the remote control
unit may cause unintended operations to occur on
other infrared-controlled equipment.
Installing the batteries
Open the cover on the back panel of the remote con-
trol unit, and install two batteries (AAA size) in the
correct orientation as indicated by the “+” and “-”
markings on the case.
When to replace the batteries
If the range of control has lessened, or if pressing a
button does not produce an operation, please replace
both batteries with new ones.
Caution regarding batteries
Incorrect use of batteries may cause leakage or burst-
ing. Please carefully read and observe the following
cautions.
• Be sure to insert the batteries in the correct orien-
tation as indicated by the “+” and “–” markings
on the battery case.
• Do not mix new batteries with old batteries, or
batteries of differing types.
• Never attempt to recharge batteries.
• Remove the batteries if you won’t be using the
remote control unit for an extended period (more
than one month).
• If leakage occurs, carefully wipe off any liquid
from inside the case and install new batteries.