Filter
Top Products
31
ENGLISH
6 – CD-R/CD-RW disc operations
Caution
Be careful that the power is not accidentally turned off
while the finalize, un-finalize, refresh, or disc/track erase
operations are being executed. If this occurs, the data on
the disc will be corrupted, and it is also possible that the
disc itself will become unusable.
This section explains various operations that you can
perform on a CD-R/CD-RW disc, such as finalizing a
recorded CD-R/CD-RW disc so that it can be played
on a conventional CD player, or erasing all or part of
the tracks on a CD-RW disc.
Finalizing
Finalizing is the operation of writing the TOC (Table
Of Contents: information about the recorded data,
such as the number of songs and the playback start
time of each song) to the CD-R/CD-RW media.
A disc recorded on the CDR632 cannot be played
back on a conventional CD player until the final TOC
has been written to the disc. (The CDR632 itself will
be able to play the disc even before it has been final-
ized.)
Normally, no additional recording can be done on
CD-R/CD-RW media once it has been finalized.
However in the case of a CD-RW, you can
“un-
finalize”
the disc so that additional recording can be
performed.
1 Insert a recorded CD-R/CD-RW disc into
the disc tray.
2
While stopped, press the FINALIZE/INS but-
ton on the front panel or the FINALIZE but-
ton on the remote control unit.
The display will indicate “FINALIZE?”.
If you decide to cancel the operation, press the
FINALIZE/INS button (or the FINALIZE button
on the remote control unit) once again.
3
Press the ENTER button.
The display will indicate “Sure?”.
If you decide to cancel the operation, press the
STOP button.
4
To execute the operation, press the ENTER
button once again.
Finalization will begin, and the display will indi-
cate the estimated time remaining until comple-
tion as “TOC X:XX”.
When finalization is finished, the display will
indicate “Complete”. All operating buttons are
disabled while finalization is being performed.
Un-finalizing
Un-finalizing is an operation that allows further
recording on a CD-RW disc that has been finalized.
1 Insert a finalized CD-RW disc into the disc
tray.
2
While stopped, press the ERASE/DEL button
on the front panel (or the ERASE button on
the remote control unit), and use the MULTI
JOG dial (or the SKIP buttons on the remote
control unit) to select
“UNFINALIZE?”
.
If you decide to cancel the operation, press the
ERASE/DEL button (or the remote control unit
SKIP buttons) once again.
3
Press the ENTER button.
The display will indicate “Sure?”.
If you decide to cancel the operation, press the
STOP button.
4
To execute the operation, press the ENTER
button once again.
Un-finalization will begin, and the display will
indicate the estimated time remaining until com-
pletion as “Erase X:XX”.
When un-finalization is finished, the display will
indicate “Complete”.
2
3, 41
2
3, 41