Filter
Top Products
34
ENGLISH
7 – Entering names
Caution
If you turn off the power without finalizing after entering a
name, the TOC will not be written, and the name you
entered will be discarded. You must execute the finalize
operation to write the TOC.
You can use the
“TEXT EDIT?”
menu item to enter a
name for a disc or track.
Naming a disc
Here’s how to assign a name to a CD-R/CD-RW disc.
1 While stopped, access the “TEXT EDIT?”
menu item and press the ENTER button.
The display will indicate “Text> XXX” (you can
choose Disc or a track number 01–99).
2
Press the ENTER button, and use the MULTI
JOG dial (or the SKIP buttons on the remote
control unit) to select
“Text> Disc”
.
3
Press the ENTER button.
The character display area will show the current
disc name, and name edit mode will be active (the
cursor will blink).
4
Enter a name as described below, and press
the MENU button on the front panel (or the
MENU button on the remote control unit) to
finalize your input.
In name edit mode, you can assign a name as follows.
To select the type of characters
Press the DISPLAY button on the front panel or
remote control unit to switch between the following
two types of characters.
• Lowercase alphabet/Symbols (nothing shown in
display)
• Uppercase alphabet/Symbols (“CAPS” lit in dis-
play)
To enter characters
Use the MULTI JOG dial (or the SKIP buttons on the
remote control unit) to select characters, and press the
ENTER button to confirm your choice.
To move the cursor
Use the SYNC REC/< button or FADER/> button.
Pressing the SYNC REC/< button moves the cursor to
the left, and pressing the FADER/> button moves the
cursor to the right.
You can also use the remote control unit SYNC REC
or FADER buttons to move the cursor.
To delete characters
Move the cursor to the character you want to delete,
and press the ERASE/DEL button (or the ERASE
button on the remote control unit).
To insert characters
Locate the cursor on where you want to insert a char-
acter, and press the FINALIZE/INS button (or the
FINALIZE button on the remote control unit).
To correct characters
Move the cursor to the character you want to correct,
and enter the desired character.
If you’ve edited text and then attempt to remove the
disc without writing the TOC, a message of
Sure?
Text!
will appear. If you want to remove the disc with-
out writing the TOC, press the (Open/Close) but-
ton once again while the
Sure? Text!
message is
shown (the text you entered will be discarded).
2, 31