Filter
Top Products
this case, the appropriate processing mode
will be selected.
Highlight the desired mode and press Enter.
When completed, highlight OK and press
Enter to return to the link input menu. Select
another video input to I!#~k or press Previous
to return to the configu~ inputs menu.
Direct Access Remote Control
System Programming
System programming functions allow you to
simplify the use of your Audio + Video
Standard by naming three sets of linked
inputs, System 1, 2, and 3 (47). Other links
may be created in the Audio + Video
Standard, but primary, links may be set up
and remembered more easily with the
System function. For example:
System button 1 A laser disc con-
nected to the RF input and a video
input, set for MOVIE MODE.
System button 2 A DVD player con-
nected to the C1 input and a video
input, set for MOVIE MODE,
System button 3 A CD player con-
nected to an analog input and an
unused video input, set for preamp
mode.
To use the system programming function,
the basic input links need to be created.
For details, see Linking a Video Input to
an Audio Input on page 22. To assign
input links to System 1, 2, or 3, follow the
instructions below.
Push and release one of the three sys-
teaq buttons.
Decide which video input you want to
assign to the system button. Push and
hold the appropriate video button down
for approximately five seconds. Note that
the red LED in the upper left corner of the
remote control will blink. When the blink-
ing stops and the light stays lit for one
second the system is linked to the video
input you selected.
Link the video inputs to a specific audio
input and surround mode.
Selecting the Broadcast Standard
The Audio + Video Standard will operate in
both the NTSC and PAL broadcasting stan-
dards. For countries that only use the NTSC
broadcasting standard, all S-video and com-
posite video inputs are already set for prop-
er NTSC operation. For countries that use
both the NTSC and PAL broadcasting sys-
tems, the SV-3, SV-4, CV-3, and CV-4 are
factory set to the PAL operating system. To
adjust the broadcast operating settings for
any of the video inputs, enter the PAL video
setup menu located within the configure
inputs menu:
KRELL A+V STANDARD
- PAL VIDEO SETUP -
SELECT THE INPUTS THAT
HAVE PAL VIDEO SOURCES:
( )sv-1()cv-1
( ) sv-2( ) cv-2
( ) sv-3( ) cv-3
( ) sv-4( ) cv-4
OK
Highlight the inputs that have PAL video
sources attached to them and press Enter
so that an,(x) appears next to the desired
input. To defeat a PAL video source, press
Enter so the x disappears. When completed,
highlight OK and press Enter to return to the
Page 24 of 32 English KRELL
®
Audio + Video Standard