Filter
Top Products
Modifying speaker settings
To disable a speaker, highlight the appropri-
ate (×) and press Enter.
To enable a speaker, highlight the appropri-
ate ( ) and press Enter.
To change the ~ttings for the FRNT, CNTR,
SIDE, or REAR, highlight the appropriate
phrase and press Enter. The speaker setup
menu will appear:
KRELL A+V STANDARD
-SPEAKER SETUP-
F THESE SPEAKERS ARE NOT
DESIGNED TO
REPRODUCE
DEEP BASS, CHECK THE BOX
BELOW:
(
BASS LIMITED SPKR
OK
If the selected speaker does not have the
capability to reproduce low frequencies, high-
light the (), press Enter, highlight OK and
press Enter again. You will be returned to the
speaker system setup menu. The on-screen
phrase for the selected speaker will now read
BASS LIMITED.
To change the settings for the subwoofers,
highlight SUBS and press Enter. The configure
subwoofers menu will appear:
KRELL A-I-V STANDARD
- CONFIGURE SUBWOOFERS -
SELECT A CONFIGURATION:
(
SINGLE MONO SUB
(x)
DUAL MONO SUBS
( STEREO SUBS
(
FRONT & REAR SUBS
OK
Highlight the appropriate ( ) that represents
the subwoofer configuration in your system
and press Enter. The (x) will now appear
next to the new subwoofer setting. Highlight
OK and press Enter. You will be returned to
the speaker system setup menu. Highlight
OK and press Enter again to return to the
main menu.
STEP 2
LISTENING ROOM SETUP
To tell the Audio + Video Standard where
each speaker is located within the listening
room, highlight LISTENING ROOM SETUP and
press Enter. The listening room setup menu
will appear:
KRELL A+V STANDARD
- LISTENING ROOM SETUP -
LEFT
CENTER RIGHT
OFT OFT OFT
L SIDE SUB 1 R SIDE
OFT
OFT
OFT
L REAR SUB 2 R REAR
OFT OFT OFT
The 0 Fm under LEFT will be highlighted. Press
Enter and the 0 will start blinking. Use the up
scroll button (50) to increase the number
the correct distance in feet from the main lis-
tening position to the left speaker. Press
Enter again and the number will stop blink-
ing. Use the right scroll button to highlight the
0 FT under CENTER. Press Enter and the o will
start blinking. Using the same procedure as
before, input the correct distance for the cen-
ter speaker. Do the same for the remaining
speakers in the system. After all the dis-
tances are se
t,
press the Previous button
(52) to return to the main menu.
KRELL
®
Audio: + Video Standard English Page 19 of 32