Filter
Top Products
POWER ON MESSAGE AND FUNCTION MESSAGE
1
Power On Message
When you first switch the POWER on, “TH78A” or
“TH78E” appears on the display for two seconds.
You can change this factory-set message to your
own message as follows:
Changing Power-on Message
2 Function Message
When you select a function, the corresponding
function message is displayed on the LCD for two
seconds.
The message and functions are listed below.
1
Select your message by following steps 1 to 4 of the
memory write procedure on page 44.
2 Press the 0 key.
The power-on message has now been changed. If
you switch the power off and on again, your own
message will be displayed on the display for two
seconds.
j
NOTE
The above message, which is stored in message
memory channel 0, appears each time you switch
the power on.
Message
Function
AF CHG
AF INI
AF MIX
AF SEP
AS OFF
AS ON
BELL 1
BELL 2
BP OFF
BP ON
DTMF0S
DTMF2S
Transpose the two AF bands
Initial AF output setting
Mix the AF output from both bands
Separate the AF output into two bands
Automatic offsets OFF
Automatic offsets ON
Tone alert (Telephone type ring)
Tone alert (Tone alarm)
Beep OFF
Beep ON
No DTMF signal transmission delay time
Setting DTMF signal transmission delay time
(two seconds)
57