Filter
Top Products
MESSAGE TRANSMISSION AND RECEPTION
This function lets you transmit your message to the
other party or display a message from the other party
on your transceiver using the DTMF (Dual Tone Multi
Frequency) signal and alphanumeric display.
You can use the numerics 0 to 9 and letters A to Z.
The message that can be transmitted and received
at one time can be up to six characters long.
Note
This function is used with DTSS or paging.
1 Message Transmission Modes
You can transmit your message by one of the
following two methods.
n
Transmit your message directly using the DTMF
keypad. You must press the # key at the beginning
and end of the character.
See the list on the next page for combinations of
keys for alphabets.
n
Store your message in the message memory, and
transmit it.
2 Using the Message Memory.
This transceiver has 10 message memory channels.
Memory write procedure
1 Press the M key, then press the MESSAGE key to
enter the message setting mode.
2 Enter your message with the DTMF keypad. See the
list on the next page for the key combinations for
each letter.
3 If you enter the wrong message, press the VFO key
to start over step 1.
4 Press the MR key at the end.
The MESSAGE display begins flashing.
44