Filter
Top Products
Notes on simultaneous in Band reception
1 When two signals on the same band are
received simultaneously, the receive
performance, such as image interference
and sensitivity, may be reduced.
2 If the two frequencies are the same, the
volume may decrease at some VOL control
positions.
To return to normal operation press the f² key again.
10 Single Band Operation
When you press the DUAL key, the band for which
the PTT indicator is on is selected, and you can
perform a single-band operation with that band.
When you press the BAND key, the band in the
single-band operation changes.
Each time you press the DUAL key, you toggle
between single-band and dual-band operation.
11
MHz Mode
If you use this function, you can change the
frequency in l-MHz steps.
Press the MHz key.
The 100-kHz digit and lower digits of the operation
band go blank. When you turn the tuning control,
the frequency changes in l-MHz steps.
To return to the normal frequency display, press any
front panel key (except E.CHG key) or wait 10
seconds.
12 Channelized Frequency Display
The frequency display can be changed to display
channel numbers instead of the operating frequency.
This function makes use of the data you have stored
in memory for this function. Channel 1 is memory
channel 1, Channel 2 is memory channel 2, etc.
1
Turn the POWER switch off.
2 Press and hold down the 3 key, then press the
POWER switch.
Channel number are displayed for both bands
3 The channel number can be changed with the tuning
control.
4 To return to the normal frequency display, perform
steps 1 and 2 again.
52