Filter
Top Products
35
Remote Setup
Chapter Two : Setting Up PowerTouch
Calibrating the Touch Screen
After you install the batteries or reset PowerTouch, you need
to calibrate the touch screen. The touch screen responds to
pressure from the included stylus or your finger:
If you are replacing batteries and complete the battery re-
placement within 3 minutes, you do not need to calibrate
the screen; calibration is stored in memory.
If the screen’s performance begins to change, you can
recalibrate it without resetting PowerTouch by pressing
on the Setup Preference menu. For more informa-
tion about accessing this menu, see “Identifying Devices
For PowerTouch Control” on page 40.
To calibrate the touch screen, use the stylus to touch the cen-
ter of each of the calibration points displayed:
When you touch each calibration point, you should hear a
beep and see the next point, indicating that area of the screen
is now calibrated. If you do not hear a beep, touch the cali-
bration point until you do.
The touch screen is sensitive to pressure, not to movement.
Press firmly but gently on any touch screen element. The screen
will not respond if you simply brush the stylus or your finger
along the surface.
Resetting PowerTouch
If you want to reconfigure PowerTouch, you can reset it.
You do not need to do this unless you experience a prob-
lem.
1. Open the cover.
2. Use the stylus to press the blue button at the bottom of
the battery case:
The items you set up in this chapter will remain in
PowerTouch. If you want to make it to the factory–set de-
fault condition, please follow the instructions on page 104
of the Users’ Guide.
Selecting the Model Type
If you committed mistake in the model type selection, re-
start it as follows.
• While holding the CONFIRM and VOLUME DOWN
buttons together, press and release the RESET button
under the battery cover (see above diagram). Do not
release the CONFIRM and VOLUME DOWN buttons
until a short beep indicating the completion of setting
is heard.
After the above, all settings are reset to the factory set-
tings.
After “Calibrating the Touch Screen”, the “Selecting the Model
Type” display appears automatically (Except for U.K.).
The model type selection is performed to let the PowerTouch
recognize the type of the receiver.
Once the model type is selected, it does not have to be se-
lected again even after PowerTouch is reset.
To set the model type:
1. Press the receiver’s ON STANDBY button to turn it ON.
2. Aim the PowerTouch towards the receiver and press the
in the display.
3. The receiver automatically transmits its type code to
PowerTouch. When the PowerTouch stores it, the model
type selection is complete.
Now the new PowerTouch is available for operation.
• If the model type cannot be selected automatically be-
cause the receiver is not ON, etc., the model type can be
selected manually. In this case, select the “Model 2” in
step 2 above.