Filter
Top Products
34
Remote Setup
Chapter Two : Setting Up PowerTouch
Chapter Two: Setting Up PowerTouch
Your new PowerTouch controls your new receiver and can
be set up to control most components attached to it.
PowerTouch appears and functions a little differently from
traditional remotes. It incorporates sophisticated engineer-
ing and design to allow you to simply touch the screen to
press buttons and operate controls. You can touch the screen
with your finger or with the stylus stored at the top of the
PowerTouch.
Because it can control so many different devices, it presents
a separate set of controls for each device on an LCD screen.
Touch an icon on the screen to access further menus or con-
trols for devices.
Only devices previously identified and connected to the
receiver will appear as icons on the display screen. If you
are “missing” an icon on your display screen, make sure
you have identified the device to PowerTouch. This chapter
describes identifying devices to PowerTouch.
Installing the Batteries
Before you can set up any PowerTouch item, you need to
install batteries.
• The batteries that came with your new PowerTouch are
intended for you to use for an operation check—they
may not last as long as ordinary batteries. We recom-
mend replacing them with alkaline batteries for nor-
mal use.
To install the batteries:
1. Press down and back on the battery cover to remove it.
2. Insert six AA (LR6) batteries as shown:
3. Close the cover.
If you use PowerTouch outside of it’s range (see “How is
PowerTouch Powered?” on page 5 of the Users’ Guide)
PowerTouch’s display may show incorrect information.
When your batteries begin to run low, PowerTouch displays
a Low Battery message. Clear the message by touching check
mark icon (
) and replace all batteries as described here.
Maximize the life of your batteries by turning the Backlight
off if you are not trying to use PowerTouch in the dark. For
more information on the Backlight, see page 73 of the Us-
ers’ Guide.
This chapter contains the following sections:
Installing the Batteries page 34
Calibrating the Touch Screen page 35
Selecting the Model Type page 35
Navigating PowerTouch Interface page 36
Setting Up Speakers page 37
Identifying Devices For PowerTouch Control page 40
Storing Radio Stations in Memory page 41
If you cannot see anything on the screen after replacing
batteries, try to adjust the screen contrast. See 74 page of
the Users’ Guide.
(for U.K. only)
If you are installing the receiver in a home entertainment
closet, a simpler installation option is to use the External
Infrared Receiver. For more information, see “Connecting
the External Infrared Receivers (for U.K. only)” on page 51.