Filter
Top Products
11
C-V750 (En/T)
In case of difficulty
Remote control unit
÷ Batteries are exhausted.
÷ The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle in between.
÷ The audio cords and system control cords are
not connected properly.
÷ The source component to be operated does not
contain the tape(s) or disc.
÷ Batteries are exhausted.
÷ Batteries are removed while something is dis-
played.
÷ Replace with new batteries. #
÷ Operate the remote control unit within the
controllable range.
@
÷ Connect properly referring to “System con-
nection”.
58
÷ Place the tape(s) or disc in the source compo-
nent to be played.
÷ Replace with new batteries.
#
÷ Remove and replace batteries after the infor-
mation display has disappeared.
Remote control operation is not possible.
The GRC screen is not displayed.
The GRC display is abnormal.
RemedyCause
Symptom
Please note that the following items will be deleted from
this unit’s memory if the power cord is disconnected
from the AC outlet for approximately three days.
÷ The input selection is cleared and the TUNER input is selected.
÷ The volume setting is cleared and the volume is set to -65 dB.
÷ The receiving band setting is cleared and the FM band is selected.
÷ The frequency setting is cleared and 87.5 MHz is selected.
÷ The preset station memory is cleared.
÷ The voice activation setting is cleared and the activation by non-
specified person is set.
÷ The surround setting is cleared and reset to the initial condition.
÷ The clock and timer setup is cleared and the clock display shows
AM 12:00 which is blinking.
Memory backup function
Set up code chart
Although each setup code is designed to work with a number of different models, certain codes may not work with some
models. (Also, certain codes may only operate some of the functions available on a given model.)
With some models, be sure to keep the ENTER key pressed for a while.