Filter
Top Products
15
C-V750 (En/T)
ON/STANDBY
MUTE
VOLUME
ENTER
Setup
DVD/6ch Input
Sound Speaker
C D
Sat.
Tape1
Cable
Reset
VCR1
VCR2
L D
T V
Confirm
Set Up
Return
Input
Source
Main Menu
TapeA
TapeB
Tape1
LD
Tuner
CD
VCR2
VCR1TVSat.Cable
1
2
VCR1
1
2
3
4
5
6
7
8
9
0
Set
000
Set Up
ENTER
ENTER
ENTER
Set
431
Setting up the GRC according to other components
(Set Up)
The GRC can also be used to remote control other compo-
nents which are not connected through system control
cords. To control another component, it is required to regis-
ter the setup code corresponding to it beforehand. E
Registering setup codes for VCR 1
Find the setup code of the component to be registered by referring to the Setup code chart in this manual.
Enter the setup code.
1 Select the ”Set Up“ icon.
2 Enter the selection
(by pressing the ”ENTER“ key).
3 Select the ”VCR 1“ icon.
4 Enter the selection
(by pressing the ”ENTER“ key).
5 Enter the setup code.
6 Select the ”Set“ icon.
7 Enter the selection
(by pressing the ”ENTER“ key).
Use the numeric keys as shown below.
Entry examples:
431 .....4
ENTER
3
ENTER
1
ENTER
400 .....4
ENTER
)
ENTER
)
ENTER
Registering setup codes of other components
The procedure of steps 1 and 2-1 to 7 of “Registering
setup code for VCR 1” also allows to register the compo-
nents listed below to remote control them from the GRC.
Main operation menu
(The displayed icons are variable depending
on the model.)
Setup of the Graphical Remote Control (GRC) unit
Registering setup code for VCR 2
Registering setup code for TV
Registering setup code for CABLE
Registering setup code for SATELLITE
Registering setup code for LD player (IR)
Check the operation of the component.
1 Display the operation screen of the component to be checked.
2 Turn on the component from the GRC and confirm the
actual component.
÷ If there is more than one setup code, input each code to see
which one turns the power on. That will be the correct code for
your component.
Although each setup code is designed to work with a
number of different models, certain codes may not work
with some models. (Also, certain codes may only operate
some of the functions available on a given model.)
With some models, be sure to keep the ENTER key
pressed for a while.
÷ When a code which is not shown in the setup code chart is entered,
the entered code disappears automatically.
Note
Note