Filter
Top Products
20
C-V750 (En/T)
ON/OFF SE
VOICE
ACTIVATE
ON/STANDBY
System component startup by voice activation
When the VOICE ACTIVATE ON/OFF key is set to ON, speak-
ing a previously recorded word into the exclusive micro-
phone switches the system components from standby mode
to ON mode.
The voice activation can use either the preset word
(“KENWOOD”) (spoken by any person) or the desired words
recorded by the user (spoken by a specific person(s)).
If the system is not activated properly by your pronuncia-
tion of “KENWOOD”, it is recommended to record your
own words and use them for the voice activation (specific
person).
¡
Starting the system components by voice activation
(by any person)
Preparation for voice activation (when the system is to be activated by speaking “KENWOOD”)
1 Ensure that the exclusive microphone is connected.
5
2 Press the (ON/STANDBY) key to ON mode.
4 Press the VOICE ACTIVATE ON/OFF key to ON
(so that the indicator lights in red).
3 Press the OPEN/CLOSE key to open the door.
5 Press the OPEN/CLOSE key to close the door.
6 Press the
(ON/STANDBY) key to STANDBY mode
(so that the display shows the clock information).
Lights in red.
Operation for voice activation of system components (by any person)
1 Speak “KENWOOD” into the exclusive microphone.
2 The system components are switched from standby
mode to ON mode. The input selection is switched to
CD or LD, and the corresponding component starts
playback.
Auto power-save
When the system has been started up by voice activation, it
will return to standby mode by automatically taking the
following steps.
1 The system components are started up by voice activa-
tion.
2 CD or LD starts to be played.
3 After the CD or LD playback completed, the system has
remained in stop mode for about 30 minutes.
4 The system returns automatically to standby mode.
÷ Load the CD player or LD player with the software to be played.
÷ The voice is recognized by word “KENWOOD” spoken by any person.
÷ If both the CD player and LD player have been connected, the CD player
is given the precedence.
÷ The CD player or LD player should be loaded with the software to be
played before the voice activation.
÷ If none of the CD player or LD player has been loaded with software,
the system remains in stop mode for about 30 minutes then returns
automatically to standby mode.
÷ If the input source is changed during playback of the CD or LD player
after the system has been started up by voice activation, the auto
power-save function is released.
Main unit
Each press switches the function as follows.
1 When the indicator is lit:
...........VOICE ACTIVATE is ON.
2 When the indicator is not lit:
...........VOICE ACTIVATE is OFF.