Filter
Top Products
22
C-V750 (En/T)
AV CONTROL CERTER KC-2
1
2
INPUT
4
VOLUME CONTROL
DOWN
UP
ON/STANDBY
3
ENTER
Main Menu
ENTER
VOLUME
Tape1 / MD
C D
CD
TapeA
ENTER
ENTER
ENTER
ENTER
ON/STANDBY
Playing music
The following procedure allows to play a CD or cassette
tape.
Preparations
÷ Connect components as described in “System connection”.
5
÷ Complete “Setup of the Graphical Remote Control (GRC) unit”.
@
: Keys or controls to be used in this operation
Press the ON/STANDBY key to ON.
Select the input source.
Play the selected source.
Operation on each
source component
or
or
Adjust the volume.
To
decrease
volume
To
increase
volume
To decrease volume
To increase volume
The selected source is displayed.
With the main unit operation, the input sources are switched as shown below.
*1: To change the TAPE 1 display to MD display
*2: To change the DVD-A display to the 6ch INPUT
display
To enable system-control operation, the displayed information should
be set according to the actually connected components.
0
÷ Note for using the 6ch INPUT ∞
÷ Step 3 can be omitted if the easy operation feature is available. (
One-touch operation
Pressing the play key of the CD player or cassette deck starts up the
system automatically and starts playback. When this operation is
used, steps 1 and 2 can be omitted.
(
Volume level is displayed.
÷ The time taken till the volume level is displayed is variable depending
on the current operating condition.
÷ Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (AI VOLUME function).
÷ The sound of input source cannot be listened to while TAPE 2
(MONITOR) is ON.
Main unit
GRC
Main unit
GRC
Main unit
GRC
Main unit
GRC
C
D
dB
V
O
LUME- 5)
÷ Load the CD player or cassette deck with the software to be played.
\Read the instruction manuals of the associated components.
1 VCR
2 AUX
3 TAPE 1 / MD *1
4 TUNER (frequency display)
5 CD
6 DVD-D
7 DVD-A / 6ch INPUT *2
8 LD -D
9 LD -A
0 CABLE / SAT