Filter
Top Products
13
English
4. Adjust the level of the low (LOW), middle (MID), or high (HIGH)
tones.
Using the Unit
1. Select the “LOW”, “MID”, or “HIGH” tone ranges by adjusting the cursor
keys left and right (4 or ¢).
The display changes with each press of the cursor keys as shown below.
+ Press the left (4 ) cursor key
Ô LOW Ô MID Ô HIGH Ô
Press the right ( ¢) cursor key =
2. Adjust the level of the selected tone range by adjusting the cursor keys
up and down ( ¡ or 1 ).
Pressing the ¡ cursor key increases the level in 2dB units, and pressing the 1 cursor
key decreases it in 2dB units.
• You can adjust the level between –6 dB and +6 dB in seven steps.
Using the Remote Control
1. Press the SEA CONTROL button.
2. Select the “LOW”, “MID”, or “HIGH” tone ranges by pressing the
41 or ¡¢ button.
The display changes with each press of the buttons as shown below.
+ Press the 41 button
Ô LOW Ô MID Ô HIGH Ô
Press the ¡¢ button=
3. Adjust the level of the selected tone range by pressing the 3 or 7
button.
You can adjust the level between –6 dB and +6 dB in seven steps.
5. Press the SET button.
“MANUAL 1” blinks on the display.
6. Select the number for the MANUAL setting.
Using the Unit
Press the cursor key to the right or left ( 4 or ¢ ) and select the number.
Using the Remote Control
Select the number by pressing the 41 or ¡¢ button.
The display changes with each press of the buttons or cursor keys as shown below.
On the unit:
+ Press the left ( 4 ) button
Ô MANUAL 1Ô MANUAL 2 ÔMANUAL 3 Ô
Press the right ( ¢ ) button=
On the Remote Control:
+ Press the 41 button
Ô MANUAL 1Ô MANUAL 2 ÔMANUAL 3 Ô
Press the ¡¢ button=
7. Press the ENTER button.
“MEMORY” and the selected memory number are
displayed on the screen, and the adjusted settings are
stored in memory. After a few seconds, the display reverts
to the item that was displayed before you pressed
the MENU button.
• The memory setting will appear in the S.E.A. effect mode
using the manual number.
If you store new settings to a MANUAL number that has already been used, the new settings replace
the existing setting.
SEA
CONTROL
SET
SEA
SEA
CONTROL
ENTER
SEA
SEA
CONTROL
CA-TD77R[EF]/EN/p1-25 97.7.24, 3:16 PM13