Filter
Top Products
11
English
Adjusting the Volume
Using the Unit
To increase the volume, press the right side of the VOLUME button .To decrease the volume, press the
left side of the VOLUME button .
Using the Remote Control
To increase the volume, press the up side of the VOLUME button .To decrease the volume, press the
down side of the VOLUME button .
Press the button in steps to adjust the volume level one step at a time, press the button continuously to
adjust the level continuously.
You can adjust the volume level between 0 and 50.
When the System is turned on from Standby mode, the volume is set to 0 and automatically increases
to the previous volume level. To stop this automatic volume adjustment, press the VOLUME button.
For private listening
Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers.
Be sure to turn down the volume before connecting or putting on headphones.
FADE MUTING Function ——————————————————
Set the Volume Level to 0 by pressing the FADE MUTING button on the Remote Control. Press this
button again to restore the Volume Level to its previous level.
Balance adjustment ————————————————————
You can use the Remote Control to adjust the left and right balance of the speakers.
Press the L – BALANCE – R buttons.
The display changes to show the balance adjustment.
Pressing the L button moves the pointer to the left, pressing the R button moves the pointer to the right.
Holding a button down, moves the pointer continuously.
The balance is normally set to the center position.
Note: If no adjustments are made for 4 seconds in balance adjustment mode, the display reverts to the
previous display.
Reinforcing the Bass Sound
S.A. (Signal Adaptive) BASS adjusts low tones at low volume to enhance their effect. When the volume
level is low, this enhances low tones that are normally difficult to hear and adjusts low tones to a fixed
level to reduce low tone distortion.
Press the S.A. BASS button.
The S.A. BASS button lights up.
The display changes with each press of the S.A. (Signal Adaptive) BASS button as shown below.
= SA-BASS 1 = SA-BASS 2 = OFF = (back to the beginning)
SA-BASS 2 enhances low tones more than SA-BASS 1.
To get the effect, press the S.A. BASS button and select SA-BASS 1 or SA-BASS 2. “SA-BASS 1” or
“SA-BASS 2” appears in the display and the button indicator lights up.
When listening to recording with low volume low tones, the difference between SA-BASS 1 and SA-
BASS 2 is clear. When listening to recording with louder low tones, however, the difference between
SA-BASS 1 and SA-BASS 2 may not be so clear.
To cancel an effect, press the S.A. BASS button until “OFF” appears on the display.
The S.A. BASS button indicator goes out.
Display when set for no
sound from the right speaker.
Display when set for no
sound from the left speaker.
Display at the
centre position.
VOLUME
VOLUME
FADE
MUTING
L —
BALANCE
— R
S. A. BASS
S. A. BASS
CA-TD77R[EF]/EN/p1-25 97.7.24, 3:15 PM11