Filter
Top Products
TIMER RECORDING
Page 52Friday, 8 April 2005 16:00
Filename [TH-R1R3EK_07Timer Recording.fm]
Masterpage:Left+
52
1 Disengage the timer mode.
● When lights up on the front display panel, press AUDIO
A.
● When j lights up on the front display panel, press TIMERj,
and press AUDIO A after j lights off.
● When ASAT jB lights up on the front display panel, press
SATj.
2 Press PROG to access the Programme Check screen.
● To return to the previous screen after you check the
programme, press PROG again.
To cancel the programme
● Press selection keys to select a programme to be cancelled,
then press CANCEL.
3 Press selection keys to select a programme to be changed,
then press ENTER.
4 Change the settings of the desired recording options as
required.
● Refer to steps 4 - 10 in Manual Timer Programming.
5 Press PROG to exit the programme screen.
6 Set the unit to timer standby mode.
For VIDEO Plus+ or Manual Timer Programming
● Press TIMERj so that j lights up on the front display panel.
For On-Disc Timer Programming
● Press AUDIO A so that lights up on the front display
panel.
For Automatic Satellite Programme Recording
● Press SATj for 2 or more seconds.
When Programmes Overlap Each Other
If APROGRAMME OVERLAPPEDB appears, you have another
programme overlapping the programme you have just made. Press
PROG. Programme Check screen appears and conflicting
programmes will be highlighted in pink.
Example: Programme 3
(you have just made) and
Programme 4 overlap
each other.
1 Confirm the overlapping
programmes.
NOTES:
● If you do not mind this overlap, press PROG to finish the timer
programme setting.
● Recording is performed according to the order as displayed on
the Programme Check screen. The timer programme that follows
will not be performed correctly.
To cancel the programme
Press selection keys to select a programme to be cancelled, then
press CLEAR
(o).
● ATHE TIMER PROGRAMMING SETTING WAS CANCELLEDB
appears on the TV screen for about 5 seconds, then the normal
screen resumes.
To change the programme
Press selection keys to select a programme to be changed, then
press ENTER.
● Change each setting as required.
2 Press ENTER to exit the Programme screen.
3 Press TIMERj to enter into timer standby mode.
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Overlap list remains showing the
conflicting programmes. In such a case, repeat the procedure
above until the conflict is solved.
Check, Cancel And Change Programmes
1 2 3
4 5 6
7 8 9
0
VOL
SAT
TV
AUDIO
CANCEL
SHOWVIEW/
VIDEO Plus+
PROG
CLEAR (o)
SAT j
TIMER j
AUDIO A
(FGDE)
ENTER
Selection Keys
PROGRAMME CHECK
DATE
++++++++++++++++++ NEW TIMER PROGRAMME ++++++++++++++++++
START-STOP
TV PROG
VPS/PDC
REC MODE
DISC TIMER PRGM
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
OK
SELECT
PROG
EXIT
05/07 SAT 18:10-20:00 L-1 SP
10/07 THU 19:00-20:00 7 XP
10/07 THU 19:45-20:30 7 LP
WEEKLY
ON
OFF
OFF
DAILY/WEEKLY
06/01 THU 18:10-20:00 L-1 SPON
TH-R1R3EK_00.book Page 52 Friday, April 8, 2005 4:00 PM