Filter
Top Products
Masterpage:Right+
Filename [TH-R1R3EK_05Name.fm]
Page 23Friday, 8 April 2005 16:00
INITIAL SETTINGS
23
There is a time limit when performing the following setting. If the
time is up before completing the setting, re-perform from the
beginning.
Setting The Speaker Distance
● This operation is not necessary if the Smart Surround Setup is
successful.
● By setting the distance, the unit automatically sets the delay time
of each speaker such that sound from each speaker can be
heard at the same time.
1 Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2 Press F or G to display the speaker setting on the front display
panel.
3 Press selection keys to select the distance.
Each time you press D or E, the speaker distance changes
from 0.3 m to 9.0 m in 0.3 m interval.
4 Repeat steps 2 - 3 as necessary.
Setting The Crossover Frequency
By setting the crossover frequency, frequencies lower than the
frequency being set is output from the subwoofer.
1 Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2 Press F or G to display ACROSS :B on the front display panel.
3 Press D or E to select the frequency.
Select one of the crossover frequency according to size of the
connected speaker.
Setting The Midnight Mode
You can enjoy powerful sounds at night by setting the midnight
mode.
1 Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2 Press F or G to display ANIGHT :B on the front display panel.
3 Press D or E to select the mode.
Select one of the following modes.
● Turn on the unit.
● Turn on the TV and select an input mode such as EXT1.
● Set the remote control selector switch to AUDIO.
● Press DVD on the remote control.
1 2 3
4 5 6
7 8 9
0
VOL
SAT
TV
AUDIO
DVD
(FGDE)
ENTER
SETTING
Selection Keys
Speaker
distance
Changes in the order of
FRNT LNFRNT RNCENTER
NSURR LNSURR R.
2.1m
2.4m
2.7m
3.3m
CENTER
FRNT L
FRNT R
SURR L
SURR R
3.0m
Set the distance as follows for the above case:
● Front speaker 3.0 m
● Center speaker 3.0 m
● Surround speaker 2.7 m
80Hz
Select this when using cone speaker that is about
12 cm.
100Hz
Select this when using cone speaker that is about
10 cm.
120Hz
Select this when using cone speaker that is about
8 cm.
150Hz
Select this when using cone speaker that is about
6 cm. (Default)
200Hz
Select this when using cone speaker that is about
5 cm.
NIGHT : 1
Select this when you want to reduce the
dynamic range slightly.
NIGHT : 2
Select this when you want to maximise the
compression effect. (Ideal for midnight)
NIGHT : OFF
Select this when playing back using full
dynamic range. (Midnight mode not
activated) (Default)
Each time you press D or E, the display changes as follows:
80HzN100HzN120HzN150HzN200HzN (back to the
beginning)
Each time you press D or E, the display changes as follows:
NIGHT : 1NNIGHT : 2NNIGHT : OFFN (back to the beginning)
TH-R1R3EK_00.book Page 23 Friday, April 8, 2005 4:00 PM