Filter
Top Products
Masterpage:Right+
Filename [TH-R1R3EK_05Name.fm]
Page 17Friday, 8 April 2005 16:00
INSTALLING YOUR NEW UNIT
17
NOTE:
The way of connecting the system cord varies depending on the
type of the powered subwoofer.
You can enjoy the sound of a digital component.
NOTE:
When connecting a video component such as a satellite receiver,
operate this system to listen to the sound.
Connect the AC plug only after all connections have been
completed.
● APLEASE WAITB blinks on the front display panel when the AC
plug of the center unit is connected into a mains outlet. And it
takes approximately 30 seconds for the unit to be turned on. This
is not a malfunction.
ATTENTION:
● Disconnect the power cord before cleaning or moving the system.
● Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp and pull the plug so as not to
damage the cord.
● Place the satellite speakers on a flat and level surface.
● The front and center speakers are magnetically shielded to avoid
colour distortions on TVs. However, if not installed properly, they
may cause colour distortions. So, pay attention to the following
when installing the speakers.
^ When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main
power switch again.
Some TV’s may still be affected even though you have followed
the above. If this happens, move the speakers away from the TV.
● The surround speakers are not magnetically shielded.
If it is located near the TV or monitor, it will probably cause colour
distortion on the screen. To avoid this, do not place the speaker
near the TV or monitor.
● Be sure to place the powered subwoofer to the TV’s right. If you
place the powered subwoofer to the TV’s left, keep sufficient
distance between them to prevent the TV screen from appearing
mottled.
● When installing the satellite speakers on the wall;
^ Be sure to have them installed on the wall by a qualified
personnel.
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
^ Care must be taken in selecting a location for speaker
installation on a wall. Injury to personnel or damage to
equipment may result if the speakers installed interfere with
daily activities.
Connecting The Powered Subwoofer
Connecting To A Digital Component
Connecting The Power Cord
Powered subwoofer
Align the J marks.
Align the J marks.
Center unit
System cord
(supplied)
OR
OPTICALCOAXIAL
L-1/L-2DIGITAL INPUT
Center unit
To digital optical output
Digital optical cord (not supplied)
Satellite receiver
OR
Digital coaxial
cord (not supplied)
To digital coaxial
output
Center unit Powered
subwoofer
Power cordPower cord
Plug into AC outlets.
Speaker Layout
Center speaker
Front right speaker
Powered
subwoofer
Front left
speaker
Right surround
speaker
Left surround
speaker
TH-R1R3EK_00.book Page 17 Friday, April 8, 2005 4:00 PM