Filter
Top Products
INSTALLING YOUR NEW UNIT
Page 16Friday, 8 April 2005 16:00
Filename [TH-R1R3EK_05Name.fm]
Masterpage:Left+
16
CAUTIONS:
● When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER
IMPEDANCE) indicated near the speaker terminals on the rear of
the powered subwoofer.
● DO NOT connect more than one speaker to one speaker
terminal.
Precautions for daily use
● When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
● Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat build-up.
● When holding a speaker, always grasp the lower portion. (TH-R3)
● Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially make sure
that children do not lean against them. (TH-R3).
Connecting The Satellite (Front, Center, Surround) Speakers
416
TH-R3
416
TH-R1
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Front speakers
SP-THS55F
Powered subwoofer SP-PWR1
Center speaker SP-THS55C
Surround speakers
SP-THS55S
● Connect the black cords to the black (G) terminals.
● Connect the white cords to the (F) terminals
referring to the table below:
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Grey
Speaker cord
The satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of
having speaker terminals on their cabinet.
4 m
10 m
4 m
Center speaker
SP-THS66C
Surround speakers
SP-THS66S
Front speakers
SP-THS66F
Powered subwoofer
SP-PWR3
White
Black
Black
Red
4 m 10 m
4 m
TH-R1R3EK_00.book Page 16 Friday, April 8, 2005 4:00 PM