Filter
Top Products
69
The AV COMPU LINK remote control system allows you to use the
five basic functions listed below.
Remote Control of the TV, DVD player, and VCR Using
This Remote Control
IMPORTANT:
To operate the video components using the IR signal transmitter
(supplied), place it so that it is aimed at the remote sensor(s) on the
target video component(s).
• The IR signal transmitter can send signals at a distance of 3 m (10
feet).
One-Touch Video Play
• Simply by inserting a video cassette without its safety tab into the
VCR 1 (the VCR connected to the VCR 1 jacks), you can watch
the video playback without setting other switches manually.
The receiver automatically turns on and changes the
Zone 1
source to “VCR 1.”
The Zone 1 TV automatically turns on and changes the input
mode to the appropriate position so that you can view the playback
picture.
When you insert a video cassette with its safety tab in place, press
the play (
33
33
3) button on the VCR 1 or on its remote control. Thus,
you can get the same result.
– If the receiver is already turned on with the ZONE 2 ON/OFF
lamp on the unit is lit and the source name for Zone 2 appears on
the display, the receiver changes the
Zone 2 source to “VCR 1.”
(In this case, the Zone 2 TV will not turn on.)
• When you press PLAY on the remote control supplied for this
receiver for operating the VCR 1, the receiver automatically turns
on and changes the
Zone 1 source or Zone 2 source to
“VCR 1”—depending on the ZONE 1/ZONE 2 (LEARN/
TRANSMIT) selector setting on the remote control.
– For Zone 1 operations only: The Zone 1 TV automatically turns
on and changes the input mode to the appropriate position so
that you can view the picture.
DVD
TV
VCR
DVD player
RX-DP20VBK
You can control the connected video components using this remote
control. Aim the remote control at the remote sensor(s) on the target
video component(s) or on the receiver directly.
For details, see page 73.
CONNECTIONS 3: Video Cable Connection
This receiver is equipped with video signal conversion function (for details, see “IMPORTANT” on page 12). However, with the AV COMPU
LINK remote control system, video conversion function cannot be used. So, connect the VCR and/or DVD player to the TV using only one
of the following three ways:
•The video input terminal should be correctly preset (see “p Setting the Video Input Terminals—VIDEO INPUT” on page 43);
otherwise, the correct input for this receiver will not be selected on the TV.
When connecting the source equipment to the receiver through the composite video jacks, connect this receiver
to the TV’s Video Input 2 terminal (composite video input) using composite video cables.
When connecting the source equipment to the receiver through the S-video jacks, connect this receiver to the
TV’s Video Input 1 terminal using S-video cables.
When connecting the source equipment to the receiver through the component video jacks, connect this
receiver to the TV’s Video Input 2 terminal (component video input) using component video cables.
CASE 1
CASE 3
CASE 2
Source
Equipment
RX-DP20VBK
TV
S-video cable
S-video cable
To Video Input 1
Source
Equipment
RX-DP20VBK
TV
To Video Input 2
Composite
video cable
Composite
video cable
Source
Equipment
RX-DP20VBK
TV
To Video Input 2
Component
video cable
Component
video cable