Filter
Top Products
44
English
Speaker Arrangements for DVD MULTI Playback
The following illustrations show how to obtain the optimum sound environment for the
DVD MULTI playback mode. Try to find the speaker direction and location to create the
optimum sound field.
Activating the DVD MULTI Playback
You can adjust the DVD MULTI playback mode while playing back a DVD using the
analog discrete output mode on the DVD player.
Once you made adjustments, the receiver memorizes the adjustments until you change
them. You also need to set the DVD player to the analog discrete output mode.
On the front panel:
1. Press DVD MULTI/2CH so that “DVD MULTI”
appears on the display.
2. Select the analog discrete output mode on the DVD
player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following steps.
3. Press BALANCE/SURROUND ADJUST repeatedly
until “CENTER LEVEL” appears on the display.
The display changes to show the current setting.
Using the DVD MULTI Playback Mode
This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of
the DVD player.
Before playing back a DVD, refer also to the manual supplied with the DVD player.
Note:
You can place the subwoofer
anywhere around you.
When you play back a disc on the DVD player with its analog discrete output mode
selected:
Left front
speaker
Sub-
woofer
TV
Center speaker
Right front
speaker
Right
rear
speaker
Left
rear
speaker
DVD MULTI/2CH
BALANCE/SURROUND
ADJUST
Continued to the next page.
Note:
You cannot adjust the center
speaker level when “CENTER
SPK” is set to “NONE” (see
page 24).
Note:
When you select “DVD MULTI”
as the source to play, the DSP
modes are canceled temporarily.
EN20_46.RX-774P[U]/1 98.3.10, 2:52 PM44