Filter
Top Products
19
English
Notes:
• If the wall outlet does not
match the AC plug, use the
supplied AC plug adaptor.
• The preset settings such as
preset channel and sound
adjustment may be erased in
the following cases:
– When you press
POWER
to set it in the
—
OFF
position.
– When you unplug the power
cord.
– When a power failure
occurs.
CAUTIONS:
• Do not touch the power cord
with wet hands.
• Do not pull on the power cord
to unplug the cord. When
unplugging the cord, always
grasp the plug so as not to
damage the cord.
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all connections have been
made.
1. Plug the power cord into an AC outlet.
2. Press POWER to set it in the _ON position.
The STANDBY lamp lights up. A small amount of power
is always consumed.
To shut off the power completely
Press POWER to set it in the —OFF position.
Keep the power cord away from the connecting cables and the antenna. The power cord
may cause noise or screen interference. We recommend that you use a coaxial cable to
connect the antenna, since it is well-shielded against interference.
The difference between the POWER switch and the
STANDBY/ON
button
• The POWER switch is the mains supply switch, allowing the receiver to
connect to the mains supply. To shut off the power completely, press the
POWER switch to set it in the —OFF position.
• The STANDBY/ON button is a functional on/off (standby) switch, and
does not disconnect the receiver from the mains supply. A small amount of
power is consumed even in standby mode for the receiver to accept signals from
the remote control.
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries first. When using the remote
control, aim the remote control directly at the remote sensor on the receiver.
1. On the back of the remote control, remove the battery cover as illustrated.
2. Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (–) to
(–).
3. Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use
two R03 (UM-4)/AAA (24F) type dry-cell batteries.
CAUTION:
Follow these precautions to
avoid leaking or cracking cells:
• Place batteries in the remote
control so they match the
polarity indicated: (+) to (+)
and (–) to (–).
• Use the correct type of
batteries. Batteries that look
similar may differ in voltage.
• Always replace both batteries
at the same time.
• Do not expose batteries to
heat or flame.
R03 (UM-4)/AAA (24F)
+
-
-
+
POWER
_ ON — OFF
Getting Started
EN01-19.RX-774P[U]/1 98.3.10, 2:49 PM19