Filter
Top Products
9
English
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to
connect the power supply.
Before Installation
General
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to connect.
Locations
• Install the receiver in a location that is level and protected from moisture.
• The temperature around the receiver must be between –5˚ and 35˚ C (23˚ and 95˚ F).
• Make sure there is good ventilation around the receiver. Poor ventilation could cause
overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or cabinet.
• Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the
receiver.
The number in the parentheses indicates quantity of the pieces supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
• Audio Signal Attenuating Cord (1)
• AC Plug Adaptor (1) (except for Peoples’s Republic of China)
If anything is missing, contact your dealer immediately.
Setting the Voltage Selector Switch
Before connections, always do the following first if necessary.
How to set the voltage selector:
Set the correct voltage for your area with the voltage
selector switch on the rear panel. Use a screw driver to
rotate the switch so the number the arrow is pointing at is
the same as the voltage where you are plugging in the
receiver.
127V
220V
230 – 240V
110V
LINE VOLTS
EN01-19.RX-774P[U]/1 98.3.10, 2:48 PM9