5
Getting Started
Connecting the FM and AM Antennas
AM loop antenna
(supplied)
If AM reception is poor,
connect an outdoor
single vinyl-covered wire
(not supplied).
FM Antenna (supplied)
If FM reception is poor, connect
outdoor FM antenna (not supplied).
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop antenna.
AM LOOP
FM 75
COAXIAL
AM EXT
SUB-
WOOFER
OUT
DIGITAL 1
(DBS)
DIGITAL 2
(TV)
PCM/STREAM
FRONT
SPEAKERS
REAR
SPEAKERS
CENTER
SPEAKER
DIGITAL IN
DVD COMPONENT VIDEO OUT
ANTENNA
TV TAPE / CDR DBS VCR
AUDIO
S-VIDEO VIDEO
YPB PR
DBS
IN
DBS
IN
MONITOR
OUT
MONITOR
OUT
CAUTION:
SPEAKER
IMPEDANCE
816
RIGHT LEFT
AV COMPU LINK-
RIGHT
LEFT
IN INOUT
(REC)
IN
(PLAY)
OUT
(REC)
IN
(PLAY)
DIGITAL OUT
VCR
OUT
(REC)
IN
(PLAY)
VCR
OUT
(REC)
IN
(PLAY)
RIGHT LEFT
FM 75
COAXIAL
ANTENNA
AM LOOP
FM 75
COAXIAL
AM EXT
B
FM 75
COAXIAL
1
23
1
2
Rear panel of the unit
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
1
Remove the insulation if the AM loop antenna
wire is covered with vinyl.
2
Press and hold the clamp of the terminal (1),
then insert the wire (2).
3
Release the clamp.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. Keep the
AM loop antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable (with a
standard type connector), disconnect the supplied FM antenna.
Note:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause poor
reception.
EN01_10RX-DV3SL[J]f.pm5 02.4.19, 16:005