Filter
Top Products
22
7 Auto surround—“AUTO SR”
Surround mode is automatically activated when digital
multichannel source such as Dolby Digital or DTS Digital
Surround software or 2-channel matrix source such as Dolby
Surround is played back.
You can enjoy Surround mode simply by selecting the source
(with digital input selected for that source)—Auto Surround.
Select one of the following settings:
ON :The AUTO SURROUND indicator always lights up
on the display.
•If multichannel signals come in, an appropriate
Surround mode will be turned on.
•If Dolby Digital 2-channel or DTS 2-channel
including surround signals come in, “PL II
MOVIE” will be selected.
•If Dolby Digital 2-channel or DTS 2-channel
signals without surround signals come in,
“STEREO” will be selected.
•If the other signals come in, nothing will change.
OFF : Select this to deactivate Auto Surround.
7 Video output mode—“VOUT”
After connecting your TV to the unit, register the type of the
connected output terminal—VIDEO, S-VIDEO, or
DVD COMPONENT VIDEO OUT.
Without setting this, AV COMPU LINK does not work
appropriately when DVD is selected as the source (see “AV
COMPU LINK Remote Control System” on pages 57 and 58).
Set the output terminal appropriately.
VIDEO : Select this when you connect your TV to VIDEO
jack by using a composite video cord.
S : Select this when you connect your TV to S-VIDEO
jack by using an S-video cord.
COMPNT : Select this when you connect your TV to DVD
COMPONENT VIDEO OUT jacks by using
component video cord.
Note:
•“VIDEO” is the initial setting. If you have already changed the
setting, another setting will be shown.
SPK.
DIGITAL AUTO
VOLUME
LR
SPK.
DIGITAL AUTO
VOLUME
LR
Notes:
•“ON” is the initial setting. If you have already changed the
setting, “OFF” will be shown.
• This function does not take effect in the following cases:
– While playing an analog source.
– While selecting “DGTL D.D.” or “DGTL DTS” as the fixed
digital input mode (see page 13).
• If you press SURROUND ON/OFF (SURR ON/OFF on the
remote control) with Auto Surround activated, Auto Surround
will be canceled temporarily for the currently selected source.
Auto Surround setting will be restored in the following cases:
– When you turn off and on the unit,
– When you change the source,
– When you change the analog/digital input, and
– When you reset “AUTO SR” to “ON” again.
Basic Settings
EN19-24RX-DV3SL[J]f.pm5 02.4.19, 16:0022