Filter
Top Products
57
The AV COMPU LINK remote control system allows you to operate JVC’s video components (TV and VCR) through the unit.
This unit is equipped with the AV COMPU LINK-III, which has added a function to operate JVC’s video components through the video
components terminals. To use this remote control system, you need to connect the video components you want to operate, following the
diagrams below and the procedures on page 58.
• Refer also to the manuals supplied with your video components.
CAUTION:
When connecting the TV with the
AV COMPU LINK remote control
system, connect the unit to the AV
COMPU LINK III or AV COMPU
LINK EX terminal.
DO NOT connect the unit to the AV
COMPU LINK RECEIVER/AMP
terminal.
CONNECTIONS 1: AV COMPU LINK Connection
CASE 1 When connecting the source equipment to the unit through the S-video terminals, connect this unit to the
TV’s Video Input 1 terminal using S-video cables.
CASE 2 When connecting the source equipment to the unit through the composite video terminals, connect this
unit to the TV’s Video Input 2 terminal (composite video input) using composite video cables.
CASE 3 When setting the video output mode of the built-in DVD player to “component,” connect this unit to the
TV’s Video Input 2 terminals (component video input) using component video cables.
To Video Input 1
TV
RX-DV3SL
S-video cable
S-video cable
Source
Equipment
To Video Input 2
Composite
video cable
Composite
video cable
TV
RX-DV3SL
Source
Equipment
To Video Input 2
Component
video cable
TV
RX-DV3SL
Notes:
• When connecting the unit and a TV with the AV COMPU LINK EX terminal by using a component video cable, you cannot use Automatic
Selection of TV’s Input Mode (see page 58).
• When connecting the VCR only to this unit, connect it directly to the unit using cables with the monaural mini-plugs.
CONNECTIONS 2: Video Cable Connection
This unit is equipped with three types of the video terminals—composite video, S-video, and component video, and the signals coming into
this unit through one type of video terminals can output only through the terminal of the same type. So you need to connect the VCR and TV
to this unit using one of the following two ways—CASE 1 or 2:
• When using the AV COMPULINK remote control system, set the component video input correctly (see “Video output mode” on page
22); otherwise, the correct input for this unit will not be selected on the TV.
AV COMPU LINK Remote Control System
AV
COMPU LINK III
AV
COMPU LINK
AV
COMPU LINK
EX
AV COMPU LINK-
VCR
TV
EN57-68RX-DV3SL[J]f.pm5 02.4.19, 16:0257