Filter
Top Products
62
Operating Other Manufacturers’ Equipment
Manufactures’ codes for DBS tuner
Manufacturer Codes
JVC 56, 57*, 67
Amstrad 43 – 49
Blaupunkt 30
Echostar 50, 51, 67
General Instrument 29
Goldstar 31
Grundig 32, 33
Hamlin/Re 01 – 05
Hirshmann 48, 52 – 55
Instrument 68
Itt/Nokia 34
Jerrold/G 06 – 14
Kathrein 52, 58 – 63
NEC 35, 36
Oak 15 – 17
Orbitech 48
Panasonic 18 – 20
Philips 37, 38
Pioneer 21, 22
RCA 65
Samsung 39, 40
Schwaiger 61, 64
Scientiff 23 – 25
Siemens 41, 42
Sony 66
Technisat 48
Tocom 26
Zenith 27, 28
7 To change the transmittable signals for
operating other manufacturers’ DBS tuner
1. Press and hold
STANDBY/ON DBS.
2. Press DBS.
3. Enter manufacturer’s code using
the number buttons (1–9, 0).
See to the right to find the code.
4. Release STANDBY/ON DBS.
You can turn on and off the DBS tuner:
STANDBY/ON DBS : Turns on or off the DBS tuner.
After pressing DBS, you can perform the following operations
on a DBS tuner:
TV/DBS CH + or – : Changes the channels.
1 – 9, 0, 100+ : Selects the channels.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
For channel number 135, press 100+,
3, then 5.
TV RETURN will function as the
ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Note:
• Refer also to the manual supplied for your DBS tuner.
5. Try to operate your DBS tuner by pressing
STANDBY/ON DBS.
When your DBS tuner turns on or off, you have entered the
correct code.
If there are more than one code listed for your brand of DBS
tuner, try each one until the correct one is entered.
VCRDBS DVD
TAPETV CDR FM/AM
231
564
89
7
10/0 +10
100+
EFFECT
TEST
SURR ON/OFF
SURR MODE
–
SUBWOOFER
+
CENTER
REAR·L
REAR·R
VCRDBS TV AUDIO
STANDBY/ON
*“57” is the initial JVC code.
Note:
• Manufacturers’ codes are subject to change without notice. If
they are changed, this remote control cannot operate the
equipment.
EN57-68RX-DV3SL[J]f.pm5 02.4.19, 16:0362