JVC RX-DV3SL Stereo System User Manual


 
40
To move the zoomed-in position
Press cursor 5//3/2.
To return to normal playback
Press ENTER.
Note:
While being zoomed in, the picture may look coarse.
7 Changing the VFP settingVFP
The VFP (Video Fine Processor) function enables you to
adjust the picture based on the picture tone, or personal preference.
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
Before using the remote control, press DVD to change the
remote control operation mode.
& During playback
1
Press VFP.
The current VFP setting screen appears on the TV.
2
Press cursor 3 (or 2) repeatedly to select the
VFP mode.
Each time you press the button, the VFP mode changes as
follows.
NORMAL CINEMA USER1 USER2
(back to the beginning)
NORMAL : Normally select this.
CINEMA : Suitable for a movie source.
USER1 and USER2 : You can adjust parameters that affect
the appearance of picture and store the
settings (see the right).
To turn off the VFP setting screen
Press VFP.
To adjust the appearance of the picture
When selecting USER1 or USER2, you can adjust the
appearance of picture
1
Press VFP, then press cursor 3 (or 2) repeatedly
to select USER1 or USER2.
2
Press cursor (or 5) repeatedly to select a
parameter you want to adjust.
Adjust gradually to show preferable appearance by confirming
the picture.
GAMMA : Controls the brightness of neutral tints
while maintaining the brightness of dark
and bright portions (4 to +4).
BRIGHTNESS : Controls the brightness of the screen
(16 to +16).
CONTRAST : Controls the contrast of the screen
(16 to +16).
SATURATION : Controls the color depth of the screen
(16 to +16).
TINT : Controls the tint of the screen
(16 to +16).
SHARPNESS : Controls the sharpness of the screen
(+0 to +3).
Y DELAY : Controls the color gap of the screen
(2 to +2).
3
Press ENTER.
The VFP setting screen disappears, and the following pop-up
window appears on the TV.
4
Press cursor (or 5) repeatedly to change the
setting, then ENTER.
The current VFP setting screen appears again.
5
Repeat steps
2
to
4
to adjust other parameters.
To turn off the VFP setting screen
Press VFP.
To activate your setting
Press VFP, then press cursor 3 (or 2) repeatedly to select
USER1 or USER2.
Note:
The VFP setting screen disappears if no operations are done for
more than about 10 seconds.
DVD Player Operations
ZOOM x4
Ex.: When GAMMA is selected
+
0
USER1
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
Y DELAY
+
0
+
0
+
0
+
0
+
3
+
0
+
0
GAMMA
+
0
GAMMA
+
+
VFP
10/0 +10
100+ TV RETURN
SUBTITLE
CHOICE
ON SCREEN
ANGLE
ZOOM
DIGEST
ENTER
TOP MENU MENU
RETURN
SURR MODE
DIMMER
MUTING
TV VOL VOLUME
SUBWOOFER
+
PROGRESSIVE
+
0
NORMAL
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
Y DELAY
+
0
+
0
+
0
+
0
+
3
+
0
Ex.: When NORMAL is selected
EN29-42RX-DV3SL[J]f.pm5 02.4.19, 16:0240