Filter
Top Products
45
Playing back sources from other devices
1 Press [LINE].
• Each time you press [LINE], the display
changes in the display window as follows.
- “LINE1” for selecting the device connected
to the [LINE1 IN] terminal
- “LINE2” for selecting the device connected
to the [LINE 2 IN] terminals
- “LINE3 DIGITAL” for selecting the digital
audio device connected to the [LINE 3
DIGITAL IN] terminal
2 Start playback on the connected
device.
3 Adjust the volume or the sound
quality for your preference.
• Refer to page 16.
NOTE
• Refer also to the operation manual for the con-
nected device.
• An audio signal from a device connected to the
[LINE1 IN] terminal is not output via the [LINE1
OUT] terminal.
• An audio signal from a device connected to the
[LINE 2 IN] terminals is not output via the [LINE
2 OUT] terminals.
• An audio signal from a device connected to the
[LINE 3 DIGITAL IN] terminal is not output via
the [LINE 3 DIGITAL OUT] terminal.
• When no device is connected to the [LINE 3
DIGITAL IN] terminal or the power of the con-
nected device is off, after “LINE 3 DIGITAL” is
selected, the display changes to “LINE 3
UNLOCK”.
You can select the gain of the signal from the
[LINE1 IN] terminal. Use the initial settings for nor-
mal operation. If the sound is too small or too loud,
change the settings.
1 Press [LINE] repeatedly to select
“LINE1” in the display window.
2 Press [INPUT LEVEL].
• Each time you press [INPUT LEVEL], the
display changes as follows.
“INPUT LEVEL1” : the initial setting
“
INPUT LEVEL2
”
“INPUT LEVEL3”
• The signal gain decreases in the order of
“INPUT LEVEL1”, “INPUT LEVEL2” and
“INPUT LEVEL3”.
Playing back sources from
other devices
Selecting the signal gain
Playing back sources from other devices
EX-A3[A_Ux].book Page 45 Monday, December 11, 2006 1:44 PM