Filter
Top Products
7
English
1
2
3
4
Basic connecting procedure
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the front, center and surround speakers
Note:
You can connect two pairs of front
speakers (one pair to the FRONT
SPEAKERS
1
terminals, and another pair
to the FRONT SPEAKERS
2
terminals).
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
Connecting the surround back speakers
To fully enjoy Dolby Digital EX and DTS-ES Extended Surround
(see pages 32 and 33), you need to connect the surround back
speakers through a power amplifier connected to the PRE OUT
SURR BACK jacks on the rear panel, using a cable with RCA pin
plugs (not supplied). Connect the white plug to the audio left jack,
and the red plug to the audio right jack.
IMPORTANT:
To obtain the best possible output power from the
receiver, and to prevent the receiver from being
overheated, the receiver has the SPEAKER LOAD
SELECTOR which has to be set as follows:
• Set it to “HIGH” when the impedance of the front
speakers connected is within the range of 8 Ω to 16 Ω.
• Set it to “LOW” when the impedance of the front
speakers connected is within the range of 4 Ω to 6 Ω.
Front speakers 2
Right / Left
Front speakers 1
Right / Left
Surround
speakers
Right / Left
Center speaker
RIGHT LEFT
+
–
+
–
816
CAUTION : SPEAKER IMPEDANCE
CENTER
SPEAKER
SURROUND SPEAKERS
SPEAKER LOAD SELECTOR
RIGHT LEFT RIGHT LEFT
+
–
CAUTION :
SPEAKER IMPEDANCE
4 6 LOW
8 16 HIGH
FRONT SPEAKERS
1
2
Note:
If you have selected “1SPK” for the surround back speaker quantity
(see page 22), connect the surround back speaker to the PRE OUT
SURR BACK L (left) jack.
Connecting the subwoofer speaker
You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the PRE OUT
SUBWOOFER jack on the rear panel, using a cable with RCA pin
plugs (not supplied).
Note:
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
Powered
subwoofer
R
L
CENTER
SURR
SURR BACK
FRONT
SUBWOOFER
PRE OUT
R
L
Right surround
back speaker
Left surround
back speaker
R
L
CENTER
SURR
SURR BACK
FRONT
SUBWOOFER
PRE OUT
R
L
Power amplifier
EN01-15.RX-8020V[C]_f 02.4.3, 0:24 PM7