Filter
Top Products
DriveRack
®
iii
DriveRack® User Manual
In addition to the amazing menu of processors available, the 260 also affords you the luxury of
utilizing dbx Zone-Controller series wall-mounted control panels that will allow you to remotely
control various parameters of the 260. The ZC-1 offers remote programmable Volume control to
any installation using the DriveRack 260. The ZC-2 provides programmable Volume and Mute
control. Both the ZC-1 and ZC-2 can be programmed for up to six outputs of the DriveRack
260. The ZC-3 allows Program Selection on the 260. The ZC-4 also offers Program Selection via
Contact Closure inputs for Room Combining applications. Up to six Zone Controllers can be
used with a single DriveRack 260, and can either be wired in series or parallel. The ZC-BOB
was created to accommodate “home-run” or parallel wiring to the unit. With a maximum length
of 1,000 ft. for each home run (maximum length for series cabling varies), the Zone Controllers
offer a simple way to create a simple yet elegant solution to many installation applications.
ZC-BOB ZC-1 ZC-2 ZC-3 ZC-4
0.2 Service Contact Info
If you require technical support, please see the Support section of our website at www.dbxpro.
com. If you still require assistance, please contact dbx Technical Support. Be prepared to
accurately describe the problem. Know the serial number of your device - this is printed on a
sticker attached to the chassis. If you have not already taken the time to fill out your warranty
registration card and send it in, please do so now. You may also register online at
www.dbxpro.com.
Before you return a product to the factory for service, we recommend you refer to the manual.
Make sure you have correctly followed installation steps and operation procedures. For further
technical assistance or service, please contact our Technical Support Department at (801) 568-
7660 or visit www.dbxpro.com. If you need to return a product to the factory for service, you
MUST first contact Technical Support to obtain a Return Authorization Number.
No returned products will be accepted at the factory without a Return Authorization Number.
Please refer to the Warranty information on the following page, which extends to the first
end-user. After expiration of the warranty, a reasonable charge will be made for parts, labor,
and packing if you choose to use the factory service facility. In all cases, you are responsible
for transportation charges to the factory. dbx will pay return shipping if the unit is still under
warranty.
Use the original packing material if it is available. Mark the package with the name of the
shipper and with these words in red: DELICATE INSTRUMENT, FRAGILE! Also write the Return
Authorization Number (RA#) on the outside of the box in a conspicuous location. Insure the
package properly. Ship prepaid, not collect. Do not ship parcel post.
Introduction