Filter
Top Products
49
First Time Setup
—Continued
Notes:
•
For composite video and S-Video upconversion for
the COMPONENT VIDEO MONITOR OUT 1 or
2, the HDMI Monitor setting must be set to No (see
page 45).
See page 27 for more information on video
signal flow and upconversion.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the GAME/TV jacks, for
to work properly, you must change this setting.
This setting can only be changed on the AV receiver.
Note:
• DOCK can be selected for the Tape input selector or
Game/TV input selector, but not both at the same time.
5
Press the [Setup] button.
Setup closes.
S
e
t
u
p
Changing the Input Display
1
Press the [Tape] or [Game/TV]
input selector button so that
“TAPE” or “GAME/TV” appears
on the display.
2
Press and hold down the [Tape]
or [Game/TV] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
DOCK.
For the Tape input selector, the setting
changes in this order:
For the Game/TV input selector, the
setting changes in this order:
GAME/TV
↔
DOCK
1, 2 1, 2
or
or
TAPE → MD → CDR
DOCK
→
→