Filter
Top Products
44
First Time Setup
This section explains the settings that you need to make before using the AV receiver for the very first time.
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
If you’ve connected your front speakers to the FRONT
and SURR BACK terminal posts for bi-amping, you
must change the Speaker Type setting. For hookup infor-
mation, see “Bi-amping the Front Speakers” on page 23.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Speaker Settings
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
-
TV CH
TV VOL
--
/
---
10 11 12
D.TUN
+10
0
Clear
456
789
Input Selector
Tape
Tuner
CD
Phono
Game
/
TV
Macro
12
3
VCRDVD
CDR/MD
CD
Zone
2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver
TV Dock
Cable
VOL
CH
Disc
Album
+
-
Enter
T
o
p
M
e
n
u
M
e
n
u
Display Muting
E
x
i
t
G
u
i
d
e
Prev
CH
R
e
t
u
r
n
S
e
t
u
p
Playlist
RandomRec
SAT
Zone
3
AUX 1 AUX 2
2, 3
2–5
1
1, 6
If you change these settings, you must run the auto-
matic speaker setup again (see page 53).
Receiver
S
e
t
u
p
Enter
Enter
3
Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker Set-
tings,” and then press [Enter].
The Speaker Settings menu appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Speaker
Impedance,” and use the Left and
Right [ ]/[ ] buttons to select:
4 ohms:
Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms:
Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ]
buttons to select “Speaker Type,”
and use the Left and Right
[ ]/[ ] buttons to select:
Normal:
Select this if you’ve con-
nected your front speakers
normally.
Bi-Amp:
Select this if you’ve con-
nected your front speakers for
bi-amped operation.
6
Press the [Setup] button.
Setup closes.
Enter
Enter
2-1.Speaker Settings
Speaker Impedance
6ohms
Speakers Type Normal
Enter
Enter
S
e
t
u
p