Filter
Top Products
120
Controlling Other Components
—Continued
Remote Control Codes for Integra/Onkyo
Components Connected via
Integra/Onkyo components that are connected via are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that’s not connected
via , use the following remote control codes:
•[DVD] Remote Mode button
5001:
Integra/Onkyo DVD player without
(default)
• [CD] Remote Mode button
6001:
Integra/Onkyo CD player without (default)
• [MD] Remote Mode button
6007:
Onkyo MD recorder without
• [CDR] Remote Mode button
6005:
Onkyo CD recorder without
• [DOCK] REMOTE MODE button
6003:
Onkyo RI Dock DS-A2 without (default)
Note:
• If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote opera-
tion to work properly, you must set the Input Display to
MD or CDR, respectively (see page 49).
Resetting the Remote Mode Buttons
You can reset a Remote Mode button to its default remote
control code.
You can reset the remote controller to its default settings.
1
Make sure the Integra/Onkyo component
is connected with an cable and an
analog audio cable (RCA).
See page 42 for details.
2
Enter the appropriate remote control code
to the Remote Mode button.
•[DVD] Remote Mode button
5002:
Integra/Onkyo DVD player with
• [CD] Remote Mode button
6002:
Integra/Onkyo CD player with
• [MD] Remote Mode button
6008:
Onkyo MD recorder with
• [CDR] Remote Mode button
6006:
Onkyo CD recorder with
• [DOCK] REMOTE MODE button
6004:
Onkyo RI Dock DS-A1 with
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
1
While holding down the Remote
Mode button that you want to
reset, press the TV [ ] button.
The Remote indicator flashes three
times.
2
Press the Remote Mode button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra/Onkyo DVD players and CD
players, respectively. When these but-
tons are reset, the preprogrammed
codes are restored.
Resetting the Remote Controller
1
While holding down the
[Receiver] Remote Mode button,
press the [Standby] button.
The Remote indicator flashes five
times.
2
Press the [Receiver] Remote
Mode button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
VCRDVD
CDR/MD
CD
Remote Mode
TV
Dock
Cable
SAT
TV
VCRDVD
CDR/MD
CD
Remote Mode
TV
Dock
Cable
SAT
Receiver
Standby
Receiver