Filter
Top Products
37
Using a Macro function
A series of remote controller button operations can be
memorized into the MACRO DIRECT button for one-
touch control.
Note:
You can program only one series of button operations
into the MACRO DIRECT button.
1. Press and hold down any one of the eight MODE but-
tons and press the MACRO DIRECT button. Then,
release the buttons.
When you press the MODE button, the SEND/LEARN
indicator lights up. When you press the MACRO
DIRECT button, the indicator turns off. When you
release the buttons, the indicator flashes briefly, then
lights up again.
2. Follow Steps 2 in the “Programming Macro Mode” on
page 36.
3. Press the MACRO DIRECT button to complete the pro-
cedure.
The SEND/LEARN indicator flashes twice slowly.
4. Check to see if the button has been programmed
correctly.
Point the RC-424M toward the DTR-5.1 and press the
MACRO DIRECT button, and make sure that the
device responds as programmed.
Transmitting the codes in Macro mode takes a while.
During transmission, point the remote controller
toward the device to be controlled.
Note:
• You may program up to 16 button operations into the
MACRO DIRECT button. If you try to program the 17th
step, it will be ignored.
• If you do not press any button for more than 30 sec-
onds during the procedure, the SEND/LEARN indica-
tor flashes three times quickly, then the RC-424M exits
Learning mode. Resume Step 1.
• If you make a mistake during programming, the
SEND/LEARN indicator flashes three times quickly,
then the RC-424M exits Learning mode. Resume Step
1.
• If you erase one of the operation buttons already
programmed in the MACRO DIRECT button, or if you
program a different code into such a button, the
operation button will no longer work. In this case, pro-
gram the buttons again to avoid malfunction.
Programming Macro Direct
1, 3
1
HOME THEATER CONTROLLER
RC-424M
Tip:
The codes programmed into a MACRO but-
ton will be transmitted with an interval of 0.5
seconds. However, some devices may not be
able to complete one operation in 0.5 sec-
onds and may miss the next code. In this
case, press one operation button, press the
corresponding MODE button, then press
another operation button to extend the inter-
val between the two operations up to one
second.