Filter
Top Products
22
Using Listening Mode
DTR5.1
Treble
Bass
Master Volume
Down
Up
Preset/Mode ADJ
Enter
Late Night/
Front Effect
Display
LFE Level
Control
Stereo
5 CH Stereo
DSP
Listening Mode
/DTS
Re-EQ
A
B
Phones
Dimmer
Memory
FM Mode
Tuning UpDown
Digital/
Analog
CH Level
Mode
SP/SYS
Setup
Surround
Multi CH
Input
Video 1
VCR
Video 2 Video 3 Tape
FM
AM Phono CD
DVD
Late Night/
Front Effect
LFE Level
Control
Stereo
5 CH Stereo
DSP
Listening Mode
/DTS
Re-EQ
Surround
Standby/On
Standby
Speakers
On
O
f
f
Power
HOME THEATER CONTROLLER
RC-424M
VOL button (qup/udown)
Use this button to adjust the volume level.
1. Input selector buttons
Select the desired input
source.
2. Listening Mode buttons
These button allow you to
select a listening mode.
3. Use these buttons to
set the Listening
mode parameters.
(Refer to page 23).
Volume knob
Use this knob to
adjust the volume
level.
3. Listening mode button
These buttons allow you to select a Surround mode.
2. INPUT SELECTOR buttons
Select the desired input source.
CH SEL/LEVEL+/– buttons
1. Press the MODE
AUDIO button
1. Press one of the INPUT SELECTOR buttons to select the
desired sound source.
2. Use the Listening Mode buttons to select the desired
Listening mode.
Stereo: Press this button to listen to a normal stereo audio.
/DTS Surround: Press this button when you wish to play
Dolby Pro Logic, Dolby Digital, or DTS Surround sound.
5CH Stereo: Press this button to play 5 ch stereo
sound (see page 21).
DSP √/®: Press this button repeatedly to select the
desired Listening mode. Each option appears as
shown at left.
3. Play the selected source.
Notes:
• Select a digital input to play Dolby digital or DTS
sound sources. (See page 18.)
• You cannot select Orchestra, Unplugged, Studio-Mix,
TV Logic, or 5ch Stereo if you have selected a Dolby
digital or DTS surround source.
• To play a Dolby digital or DTS Surround source, you
need to connect the sound source using the digital
input connector.
• When you play the Dolby Digital or DTS Surround
source, the DTR-5.1 automatically enters Dolby Digital
Surround (stereo) or DTS Surround (stereo) mode
respectively.
Follow the steps below to make adjustment to the
speaker level set by the Test Tone.
1. Press the MODE AUDIO button.
2. Press the CH SEL button to select a speaker.
3. Press the LEVEL +/– buttons to adjust the level.
Using Listening Mode
1
2
Stereo
DSP
Listening Mode
CH Stereo5
/DTS
Surround
Video 1
VCR
Video 2 Video 3 Tape
FM
AM Phono CDDVD
Playing the DOLBY DIGITAL source
Dolby Digital Dolby Digital (stereo)
Playing the DTS source
DTS DTS (stereo)
STEREO
PRO LOGIC
5ch STEREO
ORCHESTRA
UNPLUGGEDSTUDIO-MIX TV LOGIC
(Dolby Pro Logic)