Filter
Top Products
35
Programming the remote controller codes of other devices into the RC-424M
See page 39 for information on how to erase the learned codes from all buttons.
You can erase a learned code. You cannot erase pre-
set codes.
• Erasing a code programmed in a button
1. Press and hold down the corresponding MODE button
and press the ENT button, then release the buttons.
When you press the MODE button, the SEND/LEARN
indicator lights up. When you press the ENT button,
the indicator turns off. When you release the buttons,
the indicator lights up again.
2. Press and release the button from which you wish to
erase the learned code.
When you press the button, the SEND/LEARN indica-
tor turns off. When you release the button, the indica-
tor lights up again.
3. Press and release the same button again.
The SEND/LEARN indicator flashes twice slowly. The
learned code is erased.
Note:
• If you do not press the button in step 2 or 3 for more
than 30 seconds, the SEND/LEARN indicator flashes
three times quickly, then the RC-424M exits Learning
mode. Resume Step 1.
1. Press and hold down the MODE button from which
you wish to erase the learned code, and press the
ENT button twice. Then release the buttons.
When you press the MODE button, the SEND/LEARN
indicator lights up. When you press the ENT button,
the indicator turns off. When you release the buttons,
the indicator flashes twice slowly, then lights up
again.
2. Press and release the same MODE button again.
When you release the button, the SEND/LEARN indi-
cator flashes twice slowly. The learned code is
erased.
Note:
• If you do not press any button for more than 30 sec-
onds, the SEND/LEARN indicator flashes three times
quickly, then the RC-424M exits Learning mode.
Resume Step 1.
• If you make a mistake during programming, the
SEND/LEARN indicator flashes three times quickly, the
RC-424M exits Learning mode. Resume Step 1.
• If have programmed many button operations to a
single MODE button, the SEND/LEARN indicator may
remain illuminated continuously in Step 2. This is not
malfunction.
Erasing a learned code
Erasing a learned code from a MODE button
SEND/LEARN
indicator
MODE
buttons
ENT
HOME THEATER CONTROLLER
RC-424M
SEND/LEARN
indicator
MODE
buttons
ENT
HOME THEATER CONTROLLER
RC-424M