Filter
Top Products
16
Speaker setup
HOME THEATER CONTROLLER
RC-424M
3. CH SEL button
1. MODE AUDIO button
2.
3. LEVEL +/– buttons
2. VOL q/u buttons
4.
TEST button
Use the remote controller and produce the test tone to
adjust the level of the connected speakers.
1. Press the MODE AUDIO button.
2. Press the TEST button.
Each speaker produces the test tone (pink noise) in
the following order:
No sound will be output from the speakers for which
the CONFIG parameters is set to NO or NONE.
3. To adjust the level of each speaker, press the CH SEL
button to select a speaker and press the LEVEL +/–
buttons to raise or lower the level.
The test tone should sound at the same level when
you hear it in your listening position. You can adjust
the level in the range between –12dB and +12dB.
If the speaker level is set to +1dB or higher, the maxi-
mum level indicated on the display will change if you
raise the volume level. Refer to “About volume (VOL-
UME)” on page 20 for more information.
4. Press the TEST button to complete adjustment.
Note
• The Test Tone function is not available when Speakers
B is selected, when the headphones are connected,
or when Multi CH Input is selected.
Test Tone
LEFT (Front L ch)
L-SURROUND
CENTER
RIGHT (Front R ch)
R-SURROUND
SUBWOOFER
(Center ch)
2
3
1
dB
4
Using the Test Tone function on the main unit
1. Press the SP/SYS Setup button.
2. Press the Enter button while “SPEAKER SETUP” appears on the display.
3. Press the SP/SYS Setup button twice while “CONFIG SETUP” appears on the display.
4. Press the Enter button while “LEVEL SETUP” appears on the display.
Each speaker produces the test tone in the order described above.
5. Use the Preset/mode ADJ √/® buttons to adjust the level.
6. Press the SP/SYS Setup button to complete adjustment.