Filter
Top Products
53
OPTION menu
OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or ENTER button to execute
the item, except for the items LAMP TIME and FILTER
TIME. Then perform it according to the following table.
Item Description
AUTO SEARCH
Using the ▲/▼ buttons turns on/off the automatic signal search
function.
ON
Ù
OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN1
Ö
COMPUTER IN2
Ö
LAN
Ö
USB TYPE A
VIDEO
Õ
S-VIDEO
Õ
HDMI
Õ
USB TYPE B
• It may take several seconds to project the images from the
USB TYPE B port.
DIRECT POWER
ON
Using the ▲/▼ buttons turns on/off the DIRECT POWER ON
function.
ON
Ù
OFF
When set to the ON, the lamp in projector will be automatically turned
on without the usual procedure (
18), only when the projector is
supplied with the power after the power was cut while the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
•
After turning the lamp on by the DIRECT
POWER
ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the AUTO
POWER
OFF function
(
54) is disabled.
(continued on next page)