Filter
Top Products
28
There are fatal or non-fatal errors for which you cannot find the cause
Other sources of information
If you experience problems using your tape drive after installation, use HP Library & Tape Tools to
help you diagnose the problem (see page 25).
You will also find troubleshooting information on the HP support web site: //www.hp.com/
support/dlt1 that takes you to HP’s Customer Care web site for a wide range of up-to-date
information about your product.
The SCSI host adapter might be in a defective
expansion slot.
Move the SCSI host adapter to a different
expansion slot.
The SCSI bus might be too long Make sure the total length of the SCSI bus does not
exceed the ANSI SCSI standard of 3 meters (10
feet) for an SE bus, 12 meters (40 feet) for an LVD
SCSI bus with multiple devices, or 25 meters (82
feet) for an LVD SCSI bus with a single device.
Possible reason Recommended action
The SCSI bus might be improperly terminated. 1. If your HP Surestore DLT1 drive is the last or
only device on the SCSI bus, make sure the drive is
properly terminated. Make sure only the last
device is terminated.
2. If your HP Surestore DLT1 drive is not the last or
only device on the SCSI bus, check all SCSI cable
connections and make sure the last device on the
SCSI bus is terminated.
Dlt1getstart_int.fm Page 28 Thursday, November 16, 2000 1:47 PM