Filter
Top Products
19
There are three LEDs and an eject button on the front panel of your tape drive, as shown in figure 7.
For more information about using the eject button, see “To unload a cartridge” on page 23.
Front panel LEDs
There are three LEDs as illustrated in figure 7.
Write Protected
Write ProtectedWrite Protected
Write Protected
• On: the DLTtape cartridge is write-protected.
• Off: the DLTtape cartridge is write-enabled.
Ready
ReadyReady
Ready
• On: the DLTtape cartridge is loaded and ready to use.
• Off: no cartridge is loaded.
• Flashing: tape is in motion.
Caution
CautionCaution
Caution
• On: A calibration failure or hard read/write error occurred. Try cleaning the drive with a tape
approved for use in the DLT1 drive.
• If after cleaning, this indicator is illuminated again when you load a DLTtape cartridge: it is
probably that the DLTtape cartridge is causing problems. Try a new DLTtape cartridge. If this
condition persists with other cartridges, you can use HP Library and Tape Tools (downloadable
from the web site: //www.hp.com/support/tapetools) to help you diagnose the problem.
If the condition still continues, contact Technical Support.
• Off: Cleaning is complete or not needed.
All three LEDs
All three LEDsAll three LEDs
All three LEDs
• On: Power-On Self-Test (POST) is starting.
• Flashing: A POST error has occurred. For more information, see “Troubleshooting” on page 27.
Dlt1getstart_int.fm Page 19 Thursday, November 16, 2000 1:47 PM