Filter
Top Products
21
Device Type AVR 146 Source Input Audio Connections Video Connections
VCR, DVR, PVR, Video 1 • Video 1 Analog (inputs and outputs) •
One
of Component Video 2, Video 1 S-video
TiVo or other and
or
Video 1 Composite Video Input
audio/video recorder • Any one available coaxial or optical • For recording, use Video 1 S-video or
digital audio input with corresponding Composite Video Output, and do not use
coax digital output component video connections at all
Cable TV, Satellite, Video 2 • Video 2 Analog Inputs and •
One
of Component Video 2, Video 2
HDTV or other • Optical 1 Input S-video, Video 2 composite video input
device that delivers
television programs
TV, game console, Video 3 (front-panel jacks) • Video 3 Analog Inputs and •
One
of Component Video 2, Video 3 S-video
camera or other •
Either
Coax 3 or Optical 3 Input
or
Video 3 Composite Video Input
audio/video device
DVD Audio/Video, DVD • DVD Analog Inputs • Component Video 1 Input
SACD, HD-DVD, • 6-Channel Inputs (optional) and
Blu-ray Disc • Coax 1 Input
HDMI-capable DVD HDMI 1 • Coaxial 2 digital audio input • HDMI 1 Input
player or other audio/
video device
HDMI-capable DVD HDMI 2 • Optical 2 digital audio input • HDMI 2 Input
player or other audio/
video device
CD player CD • CD Analog Inputs and • Not required
• Any one available coaxial or optical
digital audio input
CDR, MiniDisc, Tape • Tape Analog (inputs and outputs) and • Not required
cassette • Any one available coaxial or optical
digital audio input
• Use corresponding coax digital output
INSTALLATION
Table 2 – Recommended Source Component Connections
NOTE: The AVR 146 is equipped with a total of six digital audio
inputs, four on the rear panel (Coaxial 1 and 2, Optical 1 and 2)
and two on the front panel (Coaxial 3 and Optical 3), which may
be assigned to any of the eight source inputs (DVD,Video 1
through 3, HDMI 1 and 2, CD and Tape). We recommend
certain digital audio connections simply because, as reflected in
Table A1 of the Appendix, those digital audio inputs are assigned
to those sources by default at the factory. But any digital audio
input may be reassigned to any source. Since you may not be
using all eight source inputs, you may reassign a digital audio
input that is recommended for a source you aren’t using to
another device. Table 2 is a guideline; you may need to make
adjustments to fit your system.
NOTE: It’s possible for a source to use none of the connections
named for that source. For example, you might connect your
DVD player to the Component Video 1 inputs and the Coax 1
digital audio input. However, we will refer to this source as
“DVD”, and in Step Five of the Initial Setup section you will
program the receiver so that these connections are assigned to
the DVD source. When you select “DVD” as your source using
the front panel or the remote, the correct connections for your
DVD player will be used.
We recommend connecting your various sources using the connections
shown in Table 2 below in order to simplify programming your receiver
and remote control. However, you may connect any device to any
source input.
AVR146-OM.qxd 2/5/07 3:59 PM Page 21