Filter
Top Products
Documenting Process Calibrator
Using Source Mode
57
8. Fill in the parameters as prompted. Enter the
Start Value, End Value, and Ramp Time.
9. If you want to automatically stop ramping if a trip
condition is detected, set the Trip Detect to
Enabled, and select Voltage or Continuity as
the trip function.
10. Press the Done softkey. Note the RAMP
annunciator next to SOURCE at the top of the
display.
11. Select a low-to-high ramp or a high-to-low ramp
with the Ramp Up/Down softkey.
12. To start ramping, press the Start Ramp softkey.
13. Ramping continues until a trip is detected (if
enabled), the ramp time expires, or you press
the Stop Ramp softkey.