Fluke 5725A Stereo Amplifier User Manual


 
5725A
Instruction Manual
1-4
1-2. Where to Go From Here
This manual is the operator and service manual for the 5725A. However, because the
5725A operates under the control of the 5700A Calibrator, most operating instructions
for the 5725A are in the 5700A/5720A Series II manuals. Topics such as selecting output
values, connecting to a UUT (Unit Under Test), and self calibration are covered in the
5700A/5720A Series II Operator Manual. The list below gives some specific pointers,
and the text further on describes how to use all the manuals to find 5725A information.
For More Information About: Refer To:
Unpacking and setup Section 2 of this manual
Installation and rack mounting Section 2 of this manual and the
Y5735/Y5737 Instruction Sheet
AC line power and interface cabling Section 2 of this manual
Controls, indicators, and binding
posts
Section 3 of this manual
5725A service information Sections 4 through 9 of this manual
Operating the amplifier Section 3 of this manual and Section 4 of
the 5700A/5720A Series II Operator
Manual
Cabling to a Unit Under Test Section 4 of the 5700A/5720A Series II
Operator Manual
Self calibration Section 7 of the 5700A/5720A Series II
Operator Manual
Full verification Section 3 of the 5700A/5720A Series II
Service Manual
IEEE-488 or serial remote operation Section 5 of the 5700A/5720A Series II
Operator Manual
5700A/5725A specifications Section 1 of this manual
Theory of operation Section 4 and 9 of this manual
Troubleshooting Section 6 of this manual
Ordering a part Section 8 of this manual