Extron electronic FOX 2G Tx Stereo Receiver User Manual


  Open as PDF
of 60
 
FOX 2G Tx/Rx AV • Quick Start Guide
Quick Start Guide — FOX 2G Tx/Rx AV, cont’d
QS-2
Step 8
Connect the 12 VDC power supply to the transmitter's 2 pole captive
screw connector (see page 2-10). Do not switch on the power supply.
Step 9
Connect the receiver to a low resolution video display using either
the BNC connectors (component, S-video, or
composite) or the 4-pin mini DIN (S-video
only), as shown in the gure at right and
page 2-11.
Step 10
Connect the receiver's audio output to a
sound system, using the 5 pole, 3.5 mm
captive screw connector (see page 2-12).
Step 11
If required, connect an alarm system to the receiver's 2 pole captive
screw connector (see page 2-13).
Step 12
Connect the ber optic cable(s) from the transmitter to the
back of the receiver (see the gure at right and page 2-14).
Link 1 is essential for transmission of video, audio, and
control signals from the transmitter to the receiver. Link 2 is
optional, but two-way communication from the Tx port of the
receiver is required to fully congure the system using
RS-232 commands or FOX Extender Windows Control Program.
Link 2 may be connected to another receiver in a daisy chain. In that
case, there is no return link to the transmitter (see page 2-15).
Step 13
Connect the RS-232 control device to this 5 pole captive screw
connector or the front panel Cong port. These ports are an
alternative to the transmitter ports (see steps 6 and 7 and page 3-2).
N
If the RS-232 control device is connected to the receiver, fiber
optic Link 2 is required to configure the transmitter.
Step 14
Connect the 12 VDC power supply to the receiver's 2 pole captive
screw connector (see page 2-10).
Step 15
Power up all devices and congure the system using the Simple
Instruction Set (SIS) commands (see page 3-5) or FOX Extender
Windows Control Program (see page 3-15).
RxTx
OPTICAL
Y/VID
R-YS-VID
B-Y/C
Y/
VI
D
S-video
R
-
Y
B
-Y
/C
Y/VID
R-YS-VID
B-Y/C
S
-VI
D
S-video
R
-
Y
Y/VID
R-YS-VID
B-Y/C
S
-VID
Component
Y/VID
R-YS-VID
B-Y/C
S
-VID
Composite
R
-
Y
B
-Y/
C
 previous next