Filter
Top Products
FOX 2G Tx/Rx AV • Installation and Setup
2-7
8. Pass the two legs of the U-bolt through the slotted holes
in the back of the mounting plate, around the mounting
pole, through the holes in the rubber contoured base, and
through the holes in the L bracket (see gure 2-5 below).
U-bolt
L-shaped
Bracket
Contoured
Base
Ceiling
Pole
Mount Plate
on PMK Tray
Figure 2-5 — U-bolt attachment
9. Align the two small holes in the bottom of the L-shaped
bracket with the holes in the PMK 350 base plate. Insert
and tighten the two provided 6-32 x 5/16" screws. Leave
the screws slightly loose so that the bracket can still be
adjusted.
10. Place the hex nuts on both ends of the U-bolt and hand-
tighten them.
11. Make the necessary cable connections to the
FOX 2G Rx AV, the power supply, and any other units.
12. Slide the PMK 350 along the pole to its nal position and
tighten the hex nuts, using a socket wrench.
12. Tighten the screws holding the L-bracket to the PMK 350
base plate.
13. Reattach the cover sheet (see gure 2-4).
14. Reattach and secure the front and back panels, using the
screws retained in step 1.