Filter
Top Products
FOX 2G Tx/Rx AV • Installation and Setup
Installation and Setup, cont’d
2-6
Projector mounting
Mount the FOX 2G Rx AV above a projector using an optional
Extron Projector Mounting Kit. The following intructions apply
to the PMK 350 (PN 70-563-0x). To use other projector mounting
kits, consult the appropriate manual. Mount the receiver on the
PMK 350 as follows:
1
. Remove and retain the four screws holding the front and
back panels of the PMK 350.
2. Remove the cover sheet.
3. Remove the rubber feet if these have been installed on the
bottom of the FOX 2G Rx AV.
4. Secure the receiver to the mounting tray, using two of
the 4-40 x 3/16" screws provided with the PMK 350 in
diagonally opposite corners of the receiver.
5. Mount the power supply, using the provided plastic ties or
Velcro
®
strips (see gure 2-4 below).
FOX 2G Rx AV
Y/VID
I
N
P
U
T
S
RS-232
OVER FIBER
RS-232
REMOTE
Tx Rx Tx Rx
AUDIO
L R
ALARM
12
R-Y
B-Y/C
S-VID
OPTICAL
POWER
12V
0.6A MAX
RxTx
Extron
PMK 350
Multi-product Projector
Mounting Kit
Cover Sheet
Front Plate
Rear Plate
U-bolt
Extron
FOX 2G Rx AV
Power supply
Figure 2-4 — Projector mounting
6. Add any other unit(s), as required.
7. Place the PMK 350 around the projector ceiling mounting
pole.