Filter
Top Products
FOX 2G Tx/Rx AV • Installation and Setup
2-5
Through-desk mounting
Mount the FOX 2G Tx/Rx AV through a desk or podium using
the optional Extron MBD 129 through-desk mounting kit
(PN 70-077-02) as follows:
1
. Remove the rubber feet if these have been installed on the
bottom of the unit.
2. Attach the brackets to the transmitter or receiver, using the
four 4-40 screws provided; leave the screws slightly loose.
Figure 2-3 — Through-desk mounting
3. Hold the unit in position, under the mounting surface.
Mark the location of the four screw holes and the
mounting hole to be cut in the table.
4. Remove the table material. Test the t by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse le to enlarge the hole.
5. Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" deep (6.3 mm) deep, as marked on the template.
6. Attach the brackets to the mounting surface, using the four
#8 wood screws provided with the kit.
7. Slide the device in or out until the front panel is ush with
the table surface. Tighten the screws installed in step 2.
8. If the screws are inaccessible to a screwdriver, mark the
location of the unit relative to the bracket, remove the unit
and bracket, tighten the screws and replace the unit as
described in step 6.