Filter
Top Products
FOX 2G Tx/Rx AV • Conguration
3-17
Loop-out indicator —• Only visible if the computer is
connected to the receiver.
Link 1 indicator —• Shows green when the receiver detects
light on Link 1 (connecting the Tx port of the transmitter to
the Rx port of the receiver). The receiver reports the status
to the transmitter over Link 2.
N
If the computer is connected to either of the transmitter's
control ports and Link 2 is disconnected, the Link 1
indicator will not show green because, when the receiver
detects light on Link 1, it will not be able to pass that
information to the transmitter.
Link 2 (Optional) indicator —
• Shows green when the
transmitter detects light on Link 2 (connecting the Tx
port of the receiver to the Rx port of the transmitter). The
transmitter reports the status to the receiver via Link 1.
The status area also shows the unit (the transmitter or receiver)
to which the computer is connected, the unit at the other end of
the ber optic cable and the COM port on the computer that is
connected to the unit.
It also provides information about the horizontal and vertical
frequencies of the input signal.
Memory Preset area
The Memory Preset area provides tools to save and recall
memory presets:
Figure 3-8 — Memory Preset area
Memory Presets save the values of color, tint, contrast, and
brightness.
Mute area
The Mute area provides radio buttons that allow the video and/
or audio to be muted.
Figure 3-9 — Mute area